Filtration System; Ultrasonic Intensity - Omegasonics RESTORATION PRO Operation & Instruction Manual

Filtration System

· In many applications the use of a pump and filtration system will extend the useful
life of the cleaning chemistry.
· The spray bar pushes the water surface, skimming off floating oil and debris that is
loosened by the ultrasonic cleaning.
· The filtration system will then remove the contaminants, pass the water through the
dual filters ("primary," "secondary") and spray the filtered water back into the wash
tank through the spray bar.
· The pump and heat circuits can be operated simultaneously.
· However the pump will not operate while the ultrasound is in use. Doing so would
decrease the cavitation cleaning effects of the ultrasound.
· How often you use the pump is dependent on what is being cleaned and the state of
the water (i.e. if the items are oily, then the pump should be run after each cleaning
cycle).
· To activate the filtration system, turn the selector switch marked PUMP to the ON
position.

Ultrasonic Intensity

· The dials located underneath the
control panel control the internal
generators, which are responsible for
the intensity of the ultrasound.
· The knob on the left controls the left
side of the machine and the knob on
the right controls the right side of the
machine.
· Intensity knobs should both be set at
the same position.
· The level of intensity required will be
dependent on the sensitivity of the
items being cleaned.
10