Safety Instructions; Operator Qualifications; Safety Rules - Omicron CT Analyzer Getting Started

Getting Started with CT Analyzer & CT SB2
1

Safety instructions

1.1

Operator qualifications

Working on high-voltage power equipment can be extremely dangerous. Consequently, only personnel
qualified, skilled and authorized in electrical engineering and trained by OMICRON are allowed to
operate the CT Analyzer. Before starting to work, clearly establish the responsibilities.
Personnel receiving training, instructions, directions, or education on the CT Analyzer must be under
constant supervision of an experienced operator while working with the equipment. The operator is
responsible for the safety requirements during the whole test.
1.2 Safety standards and rules
1.2.1 Safety standards
Testing with the CT Analyzer must comply with the internal safety instructions and additional safety-
relevant documents.
In addition, observe the following safety standards, if applicable:
• EN 50191 (VDE 0104) "Erection and Operation of Electrical Test Equipment"
• EN 50110-1 (VDE 0105 Part 100) "Operation of Electrical Installations"
• IEEE 510 "IEEE Recommended Practices for Safety in High-Voltage and High-Power Testing"
Moreover, observe all applicable regulations for accident prevention in the country and at the site of
operation.
Before operating the CT Analyzer, read the safety instructions in this User Manual carefully.
Do not turn on the CT Analyzer and do not operate the CT Analyzer without understanding the safety
information in this manual. If you do not understand some safety instructions, contact OMICRON before
proceeding.
Maintenance and repair of the CT Analyzer is only permitted by qualified experts at OMICRON service
centers (see "Support" on page 29).
1.2.2

Safety rules

Always observe the five safety rules:
► Disconnect completely
► Secure from reconnection
► Verify that the installation is dead
► Carry out grounding and short-circuiting
► Provide protection against adjacent live parts
4 OMICRON