Related Manuals for JD Williams Oliver Storage Unit
Summary of Contents for JD Williams Oliver Storage Unit
- Page 1 Oliver Storage Unit Assembly Instructions - please keep for future reference YO828 464/3944 Dimensions Width - 30cm Depth - 30cm Height - 86.5cm Important – Please read these instructions fully before starting assembly Issue 1 - 23/10/17...
- Page 2 Safety and Care Advice Important – Please read these instructions fully before starting assembly • Check you have all the • During assembly do not stand • We do not components and tools listed on or put weight on the product, recommend the use page 2 this could cause damage.
- Page 3 Components - Panels Please check you have all the panels listed below Top Panel x 1 Middle Panel x 1 Left Side Panel x 1 Right Side Panel x 1 (30(w) x 30(d) cm) (30(w) x 30(d) cm) (56.5(h) x 29.8(d) cm) (56.5(h) x 29.8(d) cm) Shelf Panel x 1 Base Panel x 1...
-
Page 4: Tools Required
Components - Fittings Note: may be supplied than are required. 14mm Screw x 6 14mm Screw x 12 Hinges x 2 Dowel x 12 14mm Screw x 1 Shelf Supports x 4 Washer x 2 Handle x 1 18mm Screw x 1 Wall Strap x 1 Panel Stiffeners x 6 50mm Screw x 4... - Page 5 Adjusting Hinges Hinge adjustment: a: To move the top panel up or down, loosen screws shown and move top panel to suit b.To move the top panel in or out, loosen screws shown and move top panel to suit. Retighten screws C:To move the top panel left or right, adjust screws shown.
- Page 6 Assembly Instructions Step 1 1. Into the underside of Top Panel 1 Middle Panel and Side panels 3 and insert a total of 12 x Male Camlocks as shown. Step 2 1. Insert 4 x Dowels into the ends of 4 x Upright Bars 2.
- Page 7 Assembly Instructions Step 3 1. Into Base Panel 2 insert 4 x Dowels D as shown. 2. Connect Side Panels 3 and 4 to base Panel 5 3. Into the underside of Base Panel 5 Insert 4 x Female Camlocks as shown.
- Page 8 Assembly Instructions Step 6 1. On the reverse of the unit install 6 x Panel Stiffeners M as shown using 6 x Screws C 2. To Top Panel 1 fit 1 x Wall Strap L as shown using 1 x Wahers I and Screw G Step 7 1.
- Page 9 Assembly Instructions Step 8 1. Connect 2 x Hinges D to Door using 2 x Screw E per Hinge 2. Fit the door to the unit by connecting the Hinges D to Side Panel 5 using 4 x Screw E per hinge 3.