Table of Contents
Advertisement
8 R10 specification
*** OPTION
NO.8 ***
--- R10 SPECIFICATION ---
OUTPUT SPECIFICATION
PLEASE SELECT NO.(1) ? 1
OUTPUT TYPE
PLEASE SELECT NO.(1) ? 2
OUTPUT SPECIFICATION 1. COMPLEMENTARY
OUTPUT TYPE
2. BUZZER
9 R11 specification
*** OPTION
NO.9 ***
--- R11 SPECIFICATION ---
OUTPUT SPECIFICATION
PLEASE SELECT NO.(1) ? 1
OUTPUT TYPE
PLEASE SELECT NO.(1) ? 2
OUTPUT SPECIFICATION 1. COMPLEMENTARY
OUTPUT TYPE
2. SIO FLAG
10 R12 specification
*** OPTION
NO.10 ***
--- R12 SPECIFICATION ---
OUTPUT SPECIFICATION
PLEASE SELECT NO.(1) ? 1
OUTPUT TYPE
PLEASE SELECT NO.(1) ? 2
OUTPUT SPECIFICATION 1. COMPLEMENTARY
OUTPUT TYPE
2. FOUT 32768 OR 38400 HZ
S5U1C60N08D MANUAL
(DEVELOPMENT SOFTWARE TOOL FOR S1C60N08)
1. COMPLEMENTARY
2. P-CH OPEN DRAIN
1. DC OUTPUT
2. BUZZER OUTPUT
SELECTED
SELECTED
1. COMPLEMENTARY
2. P-CH OPEN DRAIN
1. DC OUTPUT
2. SIO FLAG
SELECTED
SELECTED
1. COMPLEMENTARY
2. P-CH OPEN DRAIN
1. DC OUTPUT
2. FOUT 32768 OR 38400 HZ
3. FOUT 16384 OR 19200 HZ
4. FOUT
8192 OR
9600 HZ
5. FOUT
4096 OR
4800 HZ
6. FOUT
2048 OR
2400 HZ
7. FOUT
1024 OR
1200 HZ
8. FOUT
512 OR
600 HZ
9. FOUT
256 OR
300 HZ
SELECTED
SELECTED
EPSON
3 FUNCTION OPTION GENERATOR FOG6008
Select the output specification for the R10
terminal.
Either complementary output or Pch open drain
output may be selected.
When DC output is selected, R10 becomes a
regular output port. When buzzer output is
selected, by writing "1" to the R10 register, buzzer
drive (oscillation output) signal is output from the
R10 terminal.
*
When DC output is selected, the R13 terminal
output type (see Option 11, "R13 specifica-
tion") selection is limited to DC output only.
The circuit configuration is the same as those of
the output ports R00–R03 (Figure 3.3.3).
Refer to Figure 3.3.6 for the buzzer output
waveform.
Select the output specification for the R11
terminal.
Either complementary output or Pch open drain
output may be selected.
When DC output is selected, R11 becomes a
regular output port. When SIO flag is selected, a
signal indicating the SIO operation status (RUN/
STOP) is generated from the R11 terminal.
The circuit configuration is the same as those of
the output ports R00–R03 (Figure 3.3.3).
Select the output specification for the R12
terminal.
Either complementary output or Pch open drain
output may be selected.
When DC output is selected, R12 becomes a
regular output port. When FOUT is selected, clock
with frequency selected from the R12 terminal is
generated by writing "1" to the R12 register.
•
When DC output is selected
When the R12 register is set to "1", the R12
terminal output goes high (V
low (V
) when set to "0".
SS
Output waveform is shown in Figure 3.3.4.
R12 output
R12 register
0
Fig. 3.3.4 Output waveform at DC output selection
), and goes
DD
V
DD
V
SS
1
0
13
Advertisement
Table of Contents
