Advertisement
WIRING CONNECTIONS
Before making your connections, plan entire wire routing inside
the vehicle prior to staring the installation.
There are few acceptable ways of making a wire connections:
Solder connections, strip and tape connections and crimp connectors.
When soldering connection be careful not drop solder on interior dash
panels. When doing strip and tape wiring method, best way is to strip
insulation off a wire, make a hole in a wire and route a wire thru a
hole and then use tape to insulate. When using crimp connectors
make sure not to crimp to insulation as this may cause wire to break.
Low quality electrical tape is not a reliable insulator. It often falls
off in hot weather, always use high quality electrical tape.
Never twist and tape wires together without soldering.
Never use fuse taps as they can damage fuse box terminals.
If you use wire-tap connectors such as T-Taps, avoid using them.
These connectors are inferior in quality and should be avoided.
For help locating accessory , ground and reverse wires please see
table.1 on page 3
If vehicle is equipped with factory RSE (rear seat entertainment)
system and customer would like to display factory installed RSE
system on the front navigation screen, it is possible to get it
done. Simply tap in to the factory video signal with the RCA wire
and connect that RCA wire to video 1 input of an AXXESS.i
AXi-RGB2/AXi-RGB3 video interface.
INSTALLATION LOCATION: Installation of the internal
board AXi-MBEIRC-R is done at the navigation radio headunit.
See page 6-10 for details.
5
Advertisement
