Advertisement
Testing AXXESS.i Operation
Step 1: Turn on the ignition switch, check to see if status LED is on.
Step2: Test operation of video 1 input/smartphone input (AXi-RGB3),
engage the parking brake and press the push button once, video 1 or
smartphone(AXi-RGB3) input should turn on. OSD (on screen display)
on the screen will display "Video 1"or "smartphone input" (AXi-RGB3)
on the top left corner of the vehicles screen, connected video source
will display on the screen, if no video source is connected OSD on the
screen will display a "no signal" message.
Step 3: If an aftermarket back-up camera was installed, test proper
operation of the back-up camera by shifting vehicle into reverse gear.
Camera will display on video 2, if no camera is connected OSD on the
screen will display a message "no camera connected". Static distance
camera lines can be turned ON or OFF, to turn the camera lines OFF,
please see installation manual of the (AXi-RGB2/AXi-RGB3) interface
you are installing for details.
To go back to the factory navigation/information screen, press and
hold the push button for 2 seconds or more. If camera is desired to
be displayed while vehicle is driving forward, please connect your
camera to accessory power and select video 2 via push button.
Step 4: If video 2 is used as an input for an external video source,
turn the static parking lines OFF, please see installation manual of the
AXi-RGB2/AXi-RGB3) interface you are installing for details.
After The Installation
• Test all functions of AXXESS.i Interface.
• Check operation of all dashboard components such Heat and AC
controls, hazard lights, headunit operation etc.
Check to see if all reinstalled panels are mounted properly.
See page 12 for detailed checklist.
11
Advertisement
