Troubleshooting; Troubleshooting Of The Product - Husqvarna X-COM R Workshop Manual

8.1 Troubleshooting of the product

Symptom
The product does not start.
A function does not start
when you push button.
Bluetooth pairing operation
not possible.
Not possible to receive phone
call.
Only sound from one loud-
speaker.
Low / unclear sound from mi-
crophone.

22 - Troubleshooting

8 Troubleshooting
Possible causes
The battery is out of power.
The cables are not connected cor-
rectly.
The battery is defective.
The circuit board is defective.
Battery overdischarge.
Software problem.
The cables are not connected cor-
rectly.
The push button adapter is defective. Replace the push button adapter.
Defective push button on circuit
board.
The product is not in pairing operation
mode.
Configuration problem.
Not the correct settings in the phone. Change the settings on the phone and do the
Software / hardware problem.
Incorrect configuration.
Software / hardware problem.
Not the correct settings in the phone. Change the balance settings in phone.
The cables are not connected cor-
rectly.
The loudspeaker is defective.
The circuit board is defective.
High sound level in the work environ-
ment.
The microphone is defective.
The cables are not connected cor-
rectly.
The circuit board is defective.
Recommended step
Charge the product for a minimum of 1h.
Use the wiring diagram to make sure that the
cables connected correctly. Replace defec-
tive cables.
Replace the battery.
Replace the product.
Charge the product for some hours.
Force shutdown (refer to the operators man-
ual). This will reset the product. Start the
product and do a test of the function.
Use the wiring diagram to make sure that the
cables connected correctly. Replace defec-
tive cables.
Replace the product.
Set in pairing operation and do the pairing op-
eration.
Force shutdown (refer to the operators man-
ual). This will reset the product. Remove the
product from the bluetooth list in the phone.
Do the pairing operation.
pairing operation.
Replace the product.
Remove the product from the bluetooth list in
the phone. Do the pairing operation.
Change the settings on the phone and do the
pairing operation.
Replace the product.
Use the wiring diagram to make sure that the
cables connected correctly. Replace defec-
tive cables.
Replace the loudspeaker.
Replace the product.
Use the boom microphone (accessory) in
high sound level work environment.
Replace the microphone.
Use the wiring diagram to make sure that the
cables connected correctly. Replace defec-
tive cables.
Replace the product.
893 - 001 -