The Dc Connector; The Loudspeakers - Husqvarna X-COM R Workshop Manual

7.7 The DC connector

7.7.1 To disconnect the DC connector
1. Disassemble the left earmuff. Refer to
disassemble the left earmuff on page 12 .
2. Disconnect the DC connector cable (A) from the
circuit board.
7.7.2 To connect the DC connector
1. Connect the DC connector (A) on the circuit board
and put the wire in a loop (B) as shown in the
illustration.
B
2. Assemble the left earmuff. Refer to
left earmuff on page 14 .

7.8 The loudspeakers

7.8.1 To remove the loudspeaker
Note: Make sure that the loudspeaker and the sealing
are in the correct position.
1. Make a note of how the cables and components are
installed before you remove the loudspeaker.
2. Disassemble the right earmuff. Refer to
disassemble the right earmuff on page 11 .
3. Disassemble the left earmuff. Refer to
disassemble the left earmuff on page 12 .
16 - Repair instructions
To
A
A
To assemble the
To
To
4. Disconnect the loudspeaker cables and remove the
loudspeaker from the circuit board.
893 - 001 -