The Strain Relief Cable - Husqvarna X-COM R Workshop Manual

7.4.4 To assemble the left earmuff
1. Connect the connectors for the strain relief cable
(A), the loudspeaker (B), the microphone (C), the
power connector (D) and the battery (E).
A
2. Install the strain relief cable (F) and the DC
connector (G).
F
3. Install the inner earmuff (H) with the 4 screws (I).
14 - Repair instructions
B
C
D
E
G
I
H
4. Install the foam rubber insert (J) and attach the
sealing ring (K).
J
5. Attach the earmuff to the headband. Refer to
remove and install the headband on page 10 .

7.5 The strain relief cable

7.5.1 To disconnect the strain relief cable
1. Disassemble the right earmuff. Refer to
disassemble the right earmuff on page 11 .
2. Disassemble the left earmuff. Refer to
disassemble the left earmuff on page 12 .
3. Disconnect the strain relief cable (A) from the circuit
board.
A
7.5.2 To install the strain relief cable
Make sure that the strain relief cable has the correct
length before it is installed.
• Cable length for headband: 400 mm.
• Cable length for helmet: 850 mm.
K
To
To
To
893 - 001 -