The Earmuffs - Husqvarna X-COM R Workshop Manual

7.3.2 To install the cable clip
1. Attach the cable clip (A) to the headband (B).
2. Push the cable clip (C) until you hear a click sound
and the cable clip locks in position.

7.4 The earmuffs

7.4.1 To disassemble the right earmuff
CAUTION: Be careful when you do work on the
wires. The wires can easily be damaged.
1. Make a note of how the cables and components are
installed when you disassemble the earmuff.
2. Remove the earmuff from the headband. Refer to
remove and install the headband on page 10 .
893 - 001 -
A
B
C
To
3. Remove the hygiene kit. Refer to
hygiene kit on page 5 .
4. Remove the 4 screws (A) and the inner earmuff (B).
5. Remove the 4 screws (C).
E
6. Lift up the circuit board (D).
7. Loosen the strain relief (E) and the microphone
connector (F).
To replace the
A
B
C
F
D
Repair instructions - 11