The Microphone - Husqvarna X-COM R Workshop Manual

7.8.2 To install the loudspeakers
CAUTION: The wires are easily damaged when
you install the loudspeakers.
1. Right earmuff: Attach the loudspeaker on the circuit
board as shown in the illustration. Connect the
loudspeaker cable to the position (A). Install the
cable (B) as shown in the illustration.
2. Left earmuff: Assemble the loudspeaker on the
circuit board as shown in the illustration. Connect
the loudspeaker cable to the position (C). Install the
cable (D) as shown in the illustration.
893 - 001 -
3. Install the loudspeakers and the sealing rings. Make
sure that the flat side of the sealing ring (F) is
installed against the flat side (G) of the
loudspeakers.
B
A
4. Assemble the right earmuff. Refer to
the right earmuff on page 13 .
5. Assemble the left earmuff. Refer to
left earmuff on page 14 .

7.9 The microphone

7.9.1 To remove the microphone
1. Make sure that the microphone and the sealing ring
are in the correct position.
2. Make a note of how the cables and components are
installed before you remove the microphone.
E
3. Disassemble the left earmuff. Refer to
disassemble the left earmuff on page 12 .
4. Disassemble the right earmuff. Refer to
D
disassemble the right earmuff on page 11 .
F
G
To assemble
To assemble the
To
To
Repair instructions - 17