EUFAB 16615 Operating Instructions Manual page 9

•
For vehicles with a start/stop system, please observe the specifications in the vehicle manual regarding charging
the battery and the connection points. In the event of further questions, contact the manufacturer of your vehicle.
•
When pulling the mains cable out of the socket, only hold the plug.
•
Never expose the charger to the vicinity of fire, heat and extensive temperatures over +40°C.
•
Do not leave the charger connected for more than 5 days.
•
Store these instructions carefully and, if necessary, pass them on to other users.
6. Operating instructions
Figure 1: Overview
1. Battery voltage display
2. 6 V charging programme
3. Winter charging programme
4. 12 V charging programme
5. Car charging programme
6. Motorbike charging programme
7. Battery charge status display
6.1 Preparation
Clean the battery pole of dust and corrosion residue. Only for open batteries: Top up with distilled water until the
minimum filling level is reached. Leave the cells of the battery open until the end of the charging process. With
maintenance-free batteries, follow the instructions of the battery manufacturer precisely.
6.2 Connecting the battery charger
Caution: Make sure that the charger is not connected to the power socket. Always first connect the red
plus cable (+) of the charger to the plus pole of the battery. Then connect the black minus cable (-) to the
minus pole of the battery. If you wish to charge the battery while it is installed, connect the black minus
cable (-) to the chassis, far away from the battery, carburettor and fuel lines. Always stick to this sequence.
Caution: After plugging the mains cable inselect the desired charging pro- gramme by operating the MODE
button multiple times. If the MODE button is not pressed, the charging process is not started. When charging
has started it is no longer possible to switch to another charging program, If you wish to work with a program
other than the set charging program, pull the plug out of the socket and wait until the display has gone dark.
Then insert the plug again and proceed as described above.
Now, connect the power plug of the charger to the mains socket. The background illumination of the display
is activated.
If the battery has been connected incorrectly (wrong poles) or the charger has no contact, the following error
message appears on the display ˝ Er 1˝. If the error message ˝Er 2˝is shown, a defective 6 V battery has been
connected, this cannot be charged using the battery charger. If the battery has been correctly connected,
the display shows the current battery voltage and the symbol for the set charging programme. By pressing
(multiple times) the MODE button, you can select the appropriate charging programme for your needs.
The charging programmes appear in the following order and may be selected by pressing the MODE button:
• Motorbike 6 V
• Motorbike 6 V winter
A MODE button
B Display
C Charging cable
D Pole callipers, red (+)
E Pole callipers, black (-)
F Mains cable
Figure 2: Display
9