Electrical Supply - FENDT Bianco Series Manual

7.3 Electrical supply

3
3
3
4
(Picture may vary somewhat from the equipment
on your camper!)
Electricity for the camper can be obtained from
the following connections:
- 230 V
-
1
- via a built-in auxiliary battery (not included).
Supply via mains connection
The camper receives its electric power supply
via the 230 V CEE feeder plug on the side wall of
the vehicle.
To connect:
• Turn off the automatic circuit breaker
• Grab the bottom of the protective cover of the
• Completely unwind the connecting cable,
1
• Turn the automatic circuit breaker
2
To disconnect:
• Turn off the automatic circuit breaker
• Press the lever
• Pull out the CEE plug
• Press the protective cover of the exterior
The 230 V system is protected by a two-pole
10 A automatic circuit breaker
locat-ed in the wardrobe. (Exceptions to this
include special installations such as ultraheat,
hot-water heating, etc. In this case, an additional
two-pole 16 A overload circuit breaker is instal-
led.)
The residual current operated device must be
checked regularly by pressing the test button.
mains connection 50 Hz.
via the base vehicle if it is connected using the
13-pole plug (limited functions)
Everything that uses 12 V, such as lighting,
water supply, etc., is available.
pressing the rocker switch down.
j
exterior socket and flip it up.
k
insert the plug and snap it into place.
on.
pressing the rocker switch down.
l
in the exterior socket
down.
socket down until it snaps into place.
l
j
m
by
m
back
m
by
k
.
m
, which is
07-5