FENDT Bianco Series Manual page 80

3
1
4
Plan for warm water supply
08-4
2
To remove water:
•
The water will be mixed to the desired
temperature according to the position of the
pre-mixing unit.
Emptying the therme:
•
Switch off the electricity for the water pump
by pressing the control panel
switch for 5 seconds.
•
Open all faucets.
•
Set all pre-mixing valves to "warm" if neces-
sary.
•
Open the drain valves
4 directly next to the therme; another 2 on the
opposite side (layout/model-specific).
•
Check to see if water runs out.
•
Close the runoff valve
necessary, blow the line out).
Electric operation:
l
•
Use the switch
the thermostat to regulate the water tempera-
ture to approx. 55° C.
• Power consumption: approx. 300 W.
Rules for the therme:
•
Switch the device off when the camper is not
being used.
•
Empty the therme at the risk of frost. Frozen
water can cause the therme to burst!
•
A depressuriser must be used if the pump is
connected to a central water supply, or on
stronger pumps. The pressure in the therme
may not exceed 1.2 bar. In addition, a safety
valve or runoff valve
cold water tap.
•
We recommend that you do not use the water
from the therme as drinking water.
Never operate the therme electrically
when it is empty.
WARNING:
The block circuit diagram only reflects the func-
tion. Due to the various floor plans, individual
modifications are possible.
l
of the main
m
.
m
after emptying (if
to turn on the therme. Use
j
must be used in the