FENDT Bianco Series Manual page 19

Bild./Fig. 10
Bild./Fig. 11
Bild./Fig. 12
Bild./Fig. 13
To operate
Condition on delivery
Clutch grip (Fig. 10/Pos.
Stabilizing lever (Fig. 10/Pos.
Preparing to hitch or unhitch
To hitch or unhitch, the stabilizing lever (Fig. 11/
k
Pos. ) must be in an upright position (open).
To hitch
Ball-shaped coupling
To open the ball-shaped coupling: pull the clutch
j
grip (Fig. 12/Pos. ) upwards in the direction of
the arrow. The coupling mechanism has an open
position, i.e. as long as the AKS 2004/AKS 3004
has not been attached to the ball the clutch grip
will stay open. Attach the open coupling to the
drawbar ball of the base vehicle. You must now
hear the clutch grip relock itself in the original
position.
In addition, press the hand grip (Fig. 13/Pos.
down by hand.
It is closed and secured automatically.
The coupling ball has been hitched
correctly when the green border of
the safety display (Fig. 13/Pos.
visible.
Stabilizing device
The AKS 2004/AKS 3004 is hitched to the cou-
pling.
Press the stabilization grip down as far as it will
k
go (Fig. 13/Pos. ) until it passes the point
where it locks into place.
To unhitch
To unhitch the camper from the base vehicle,
carry out the steps described above in the re-
verse order:
Pull the stabilization grip up as far as it will go
(upper final position of the stabilizing lever).
Open the clutch grip and lift AKS 2004/ AKS
3004 off the ball of the base vehicle.
Use a support wheel for easier hitching and un-
hitching if the drawbar load is heavier.
j
)
k
)
j
l
) is
03-3
)