Electric Floor Heating - FENDT Bianco Series Manual

7.6 Electric floor heating

(special accessory, model-specific)
The heating system is located in the middle
walking space of the floor. It is 60 cm wide; the
length depends on the type of vehicle. This heat-
ing system is not meant to heat the room; in-
stead, it reduces the loss of heat via the floor.
Switching the electrical floor heating 26V
on and off
Diamant
The switch is integrated in the control panel for
the kitchen unit.
Other models (special accessory)
External rocker switch with a symbol
Technical data
Voltage 26V~ from its own 230V/26V trans-
former.
Depending on the length of cable mounted, the-
re is a power consumption of approx. 56 W/mtr.
To prevent local hot spots, do not
place objects for a longer period of
time on the floor if the floor heating
system has been turned on. Do not
drill any holes in the floor or screw in
any screws.
Due to construction (the heating foil
is glued under the PVC flooring) slight
outlines may be visible. However, these
are not noticeable under a fitted carpet
(model/series-specific). The electrical
floor heating is operated by means
of the control switch marked with the
appropriate symbol. Depending on the
layout / type of vehicle, the transformer
for the electrical floor heating is loca-
ted either at the front or rear end of the
vehicle. It must not be covered when
loading the camper. Danger: heat build-
up! When it is in operation, the electri-
cal floor heating must not be covered
up in the middle of the storage space
under the transverse seating bench.
Danger: heat build-up!
07-15