FENDT Bianco Series Manual page 88

2
09-6
•
If the flame extinguishes again, re-ignition
1 takes place during the closing phase of the
fusible cut-out of the ignition safety switch
(approx. 30 seconds).
•
If no flame is ignited, the automatic ignitor
k
will continue to work until the operation
handle
To shut off:
•
Turn the operation handle
The automatic ignitor is thereby shut off.
•
Close the bottle valve and the quick-close
valve if the unit is not used for a longer period
of time.
Changing batteries on the automatic igni-
tor: (not for S 3002 P).
If you cannot hear any ignition sparks or only
hear them in intervals of more than one second,
then you must insert a new battery.
• Ensure that the heating has been switched
off.
• Remove the radiator cover (see Truma oper-
ating instructions).
• Push the cover of the battery compartment
up and exchange the battery (take special
note of plus and minus).
• Close the battery compartment.
• Use only a temperature-resistant (+70° C) and
leakproof mignon battery.
Please refer to the manufacturer's
separate operating manual for detailed
handling information.
j
is switched to "0".
j
Insert new batteries before the begin-
ning of each heating season.
Also note the separate operating
instructions from the manufacturer.
to position "0".