Rep; Max - PCE Health and Fitness MiniAir20 Operating Instructions Manual

MiniAir20
Mean value measurements for the parameters Flow, Temp
or RH can be performed over a certain averaging time with
the key "Rep".
An averaging time of 6 seconds is pre-programmed.
During the measurement, the remaining seconds are counted
off, after which the mean value over this time is indicated. (The
current value can be indicated during the mean value
measurement with the key "Flow/RH" or "Temp").
With Mini2Logger connected and switched on, by pressing
the ''Rep'' key for a longer time the Rep measurement is
automatically repeated and the data are transferred to the
Min2Logger between two Rep measurements.
The maximum values of the parameters Flow, Temp or RH
are indicated with the key "Max".
In the case of measurements via the mean value ("Start/Stop"
key or "Rep" key) the maximum values are indicated with the
"Max" key.
The minimum values of the parameters Flow, Temp or RH
are indicated with the key "Min".
In the case of measurements via the mean value ("Start/Stop"
key or "Rep" key) the minimum values are indicated with the
"Min" key.
Schiltknecht Messtechnik AG 35