External Devices Connection - Vega Absolute TP-11 User Manual

Vega TP-11 / User Manual
To transfer the device from the "Active" mode to the "Storage" mode, you can use the
long press of the start button (more than 5 seconds).
Before connecting the device to the network, make sure that its
registration data is entered in the network - Device EUI, Application EUI
and Application Key for OTAA, or Device address, Application session key
and Network session key for ABP

EXTERNAL DEVICES CONNECTION

The actuators are connected to the converter via outputs OUT_1 and OUT_2, which
are of the open-drain type.
Permissible load for each digital output is 200 mА
To increase the load on the device outputs, it is necessary to use an external relay. The
relay connection scheme is shown below.
Revision 09 08 April 2020
–
13