Cleaning And Care; Housing; Dirt Container; Rotary Brush - Silvercrest SABD 3.7 LI D4 Operating Instructions Manual

Cleaning and Care

DANGER! RISK OF ELECTRIC SHOCK!
D
► o not clean the appliance while charging it.
Always disconnect the battery charger
from the mains power socket before cleaning
the appliance!
NEVER immerse the appliance in water or
any other liquid!
WARNING! RISK OF INJURY!
E
► nsure that the appliance is not accidentally
switched on without the dirt container
attached or while cleaning the rotary
z
brush . Risk of injury!
ATTENTION! PROPERTY DAMAGE!
D
► o not use abrasive or aggressive cleaning
materials. These may damage the surfaces.

Housing

■ Wipe off the appliance housing with a damp
cloth. If required, use a mild washing-up liquid
on the cloth.
■ Ensure that the appliance is completely dry
before reconnecting it with the battery
w
charger .

Dirt container

To ensure that the performance of the cordless
sweeper does not deteriorate, empty the dirt
0
container after every use.
■ Press the push-in connection
0
container and pull it off.
■ Empty the dirt container
onto the appliance so that it sits firmly on the
appliance and clicks into place on the release
q
knob .
│ GB │ IE │ NI │ CY
■ 6
w
0
q
on the dirt
0
and push it back

Rotary brush

z
If the rotary brush
because coarse dirt or threads have accumulated,
proceed as follows:
Remove the rotary brush
F on the fold-out page of these operation
instructions for further guidance:
1) Turn the cordless sweeper over and hold it so
that the rotary brush
2) Pull on the hook of the catch
r
the side cover .
3) Pull the rotary brush
housing and then out to the side.
4) Remove any dirt (on both sides of the brush
bristles) and clean the rotary brush
To do this, take a damp cloth and wipe the
individual bristle bundles from the inside to the
outside.
NOTE
R
► emove hair and threads from the brush by
cutting them with the knife
them out of the rotary brush
Reinsert the rotary brush
1) Push the round end of the rotary brush
onto the drive shaft
2) Push the square end of the rotary brush
into the housing so that the rotary brush
sits straight in the housing again.
3) Replace the cover
Make sure that the catch
can no longer be turned
z
. Refer to figures E and
z
is facing towards you.
t
and remove
z
upwards out of the
z
.
e
and pulling
z
.
z
:
z
u
.
r
in the housing.
t
engages.
SABD 3.7 LI D4
z
z