JLG 1200SJP Service And Maintenance Manual page 178

Hide thumbs Also See for 1200SJP:
Table of Contents

Advertisement

3.30 DEUTZ ENGINE - TD2.9L4
NOTE: Refer to engine manufacturer's manual for detailed oper-
ating and maintenance instructions. Limited engine main-
tenance items are presented here for convenience but
detailed engine maintenance items and schedule are
included in the engine manufacturer's manual.
Glow Plugs
If the glow plug option is enabled in the JLG Control System,
the glow plug and indicator lamp will be energized when the
Power/Emergency Stop switch is pulled on if the ambient air
temperature is less than 50° F (10° C) and the engine coolant
temperature is less than 140° F (60° C). This determination will
occur one second after the Power/Emergency Stop switch has
been pulled on. The lamp and glow plugs will remain ene-
gized for the period of time specified by the setting in the JLG
Control System. Engine start shall be disabled during this
period. On Deutz engines, the glow plugs will continue (post
glow) after the engine has started for three times the machine
digit setting.
Check Oil Level
1. Make sure machine and engine are level and switch
engine OFF before checking oil level.
2. Remove oil dipstick and wipe with clean cloth.
3. Insert dipstick to the stop and remove again.
4. Check oil level. Top oil level as shown in figure below
with an approved grade and type of oil outlined in
engine manufacturer's operator's manual.
Figure 3-77. Deutz Engine Dipstick
5. Replace dipstick until fully seated.
3121142
SECTION 3 - CHASSIS & TURNTABLE
Replacing Engine Oil
1. Allow engine to warm up. Engine oil should reach
approximately 176° F (80° C).
2. Make sure machine and engine are level.
3. Switch off engine.
4. Place oil tray under engine.
HOT ENGINE OIL CAN CAUSE BURNS. AVOID CONTACT WITH HOT OIL WHEN
DRAINING.
COLLECT USED OIL IN A CONTAINER SUITABLE FOR DISPOSAL OR RECYCLING.
DISPOSE OF USED ENGINE OIL IN ACCORDANCE WITH ENVIRONMENTAL REGU-
LATIONS.
5. Open oil drain valve and drain oil.
6. Close oil drain valve.
7. Pour in new engine oil. Refer to Section 1 for capacity
and Figure 3-78., Engine Oil Viscosity.
Figure 3-78. Engine Oil Viscosity
3-129

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

1350sjp

Table of Contents