Cisco ME 1200 Series Hardware Installation Manual page 28

Initial Configuration
Controller(config-controller)#ProvisionNIDMgmtType
Controller(config-controller-ProvisionNIDMgmtType)#setiproute
setIpRouteReq ??ipv4_address 0.0.0.0
Controller(config-controller-ProvisionNIDMgmtType)#setiproute
setIpRouteReq ipv4_mask 0.0.0.0
Controller(config-controller-ProvisionNIDMgmtType)#setiproute
setIpRouteReq gateway_ip 7.6.0.1
Controller(config-controller-ProvisionNIDMgmtType)#setiproute commit
Configure the connected Cisco ME1200 NID interface as trunk and allow the specified VLAN.
Step 9
Controller#conf t
Controller(config)#controller nid 1/1
Controller(config-controller)#ProvisionPortVlanPortType
Controller(config-controller-ProvisionPortVlanPortType)# modifySwPort
modifySWPortConfig interface 1
Controller(config-controller-ProvisionPortVlanPortType)#modifySwPort
modifySWPortConfig mode trunk allowed vlan 2
Controller(config-controller-ProvisionPortVlanPortType)#modifySwPort
commit
After above steps, using 'platform nid-controller' add the NID with the desired IP.
Step 10
Controller#conf t
Controller(config)#platform nid-controller add 7.6.15.59
Controller(config)#end
Check if the Cisco ME1200 NID has been added to UPE NID Controller,
Step 11
Controller#show platform nid-controller nids
NID_ID
TFTP Server
1
n/a
2
n/a
Now, using 'controller nid 1/2' the Cisco ME1200 NID can be accessed on a different SVI.
Step 12
Cisco ME 1200 Series Carrier Ethernet Access Devices Hardware Installation Guide
2-14
MAC Address IP Address
Type
n/a 192.0.2.1
static
n/a 7.6.15.59
static
Chapter 2 Installing the Cisco ME 1200 NID
Lease Physical Port
n/a n/a
n/a n/a
VLAN
n/a
n/a
OL-31962-04