8-1. Appn Remote Workstation - IBM 3745 Console Setup Manual

o
Chapter 8. APPN-Attached Remote Workstation
o
o
c
o
D
3745 3746
TIC3 900NN
SAP=08
MAC ADDRESS=
400000502144
APPN/Attached Workstation
PU=CPCTRL1
LU=CTRLAPPN
Figure 8-1. APPN Remote Workstation
Virtual Route
APPN-NETWORK
CJ
3745 3746
900NN
Service Processor
PU=MOSSNMVT
LU=DCAFAPPN
This chapter shows you how to configure a DCAF session for controlling the
service processor (see Figure 8-1 above).
If you have more than one target service processor - - - - - - - - - - - - ,
You must respect the parameter value matching rules in Appendix A,
"Configuration for a Two-Target Remote Workstation."
Configuring a Target Service Processor
Important
------------------------------------------~
You can use the worksheets in the Planning Guide, GA33-0457 to record the
necessary parameter values described in this section.
This section describes:
• How to configure the MOSS-E for a DCAF link to the communication controller
• Which MOSS-E parameters to record for use in the controlling workstation.
© Copyright IBM Corp. 1989, 1998
8-1