Telnet Workstation Configuration - IBM 3745 Console Setup Manual

o
Chapter 9. Telnet-attached Remote Workstation
c
o
c
o
Introduction
Consoles
TCP/IP
Any workstation that runs the Telnet Client program can remotely access the IP
functions of a Network Node Processor (NNP). You can Telnet ona remote
workstation to configure and manage IP functions without disturbing the operations
of the service processor.
However, when using Telnet:
• You cannot access the MOSS-E functions
• Only one remote workstation can access a NNP at a time.
Any remote workstation can access a NNP via TeJnet.
Notes:
TCP/IP and Telnet Client programs are separate products from IBM
applications for Communication Controllers. See the documentation that comes
with these products for information on installation procedures.
Controller
Expansion
Figure
9-1.
Telnet Workstation Configuration
A Telnet remote console can be attached to the service LAN (the Service
Processor Access Unit in Figure 9-1) via a bridge with appropriate filtering, or via
an IP network using resources controlled by the target Network Node Processor
(NNP). See Figure 9-1 above.
These workstation attachments can be through either:
• LAN (Token-ring, Ethernet)
• WAN links (Frame-relay, Point-to-Point Protocol).
© Copyright IBM Corp. 1989, 1998
9-1