PRx Performance Profile PRO Squat Rack with Pull-Up Bar 96” Assembly Instructions Manual page 6

Linkage Arms to Wall Brackets
10
1. Place the small side of the Plastic Spacer (#9) in the straight, gas shock facing portion of unbent end of the
linkage arm (as pictured above)
2. Place the linkage arm with the Plastic Spacer (#9) facing the inside of the wall bracket "ear"
3. Attach using a 1 3/4" hex head bolt (#10) and 5/8" washer (#11) on the outside of the wall bracket "ear"
and a 5/8" washer and 5/8" Nyloc Nut (#12) on the opposite side
4. Tighten using a 15/16" socket and 15/16" wrench
5. NOTE: DO NOT over tighten any of the pivot points. This may result in the rack feeling "stiff " moving up
and down. It should move up and down freely
6. Repeat so all four linkage arms are attached to the wall brackets
7. NOTE: DO NOT attach the shocks to the wall brackets at this point of assembly
6
11
11
9
12
prxperformance.com