PRx Performance Profile PRO Squat Rack with Pull-Up Bar 96” Assembly Instructions Manual page 8

Attach Pull-Up Bar to Linkage Arms
Upper Linkage Arms
1. Attach the left linkage arm by removing the 5/8" x 5" hex head bolt (#13) from the top left pull up bar. Place
the Plastic Spacer on the inside of the linkage arm and place it against the top hole of the upright
2. Attach linkage arm, black plastic spacer, upright and Pull-Up Bar using the 5/8" x 5" hex head bolt, (2) 5/8"
flat washer (#11) and 5/8" Nylock Nut (#12). NOTE: DO NOT over tighten
3. Repeat on the right side
Lower Linkage Arms
1. Place Plastic Spacer on the inside of the bottom linkage arms, place it against the 19" hole of the
upright. Attach linkage arm, Plastic Spacer (#9) and upright using a 5/8" x 4 1/2" bolt (#14), (2)
5/8" washer (#11) and 5/8" Nylock Nut (#12) DO NOT ATTACH THE SHOCKS
2. Repeat on the opposite side
NOTE: DO NOT over tighten
8
14
11 9
12
11
prxperformance.com