Camera Installer - Bosch MegaPixel IP Camera NWC-0800 User Manual

18 en | Software
4.1.3

Camera installer

Camera Installer allows you to find all cameras that are present
on the local area network, assign IP addresses to the detected
cameras, and to verify that the cameras are accessible and
operational. Camera Installer saves information about installed
cameras into a dedicated file used by Video System. Camera
Installer supports two modes of operation - Basic and
Advanced.
–
Fig. 4.3 Bosch Camera Installer - Basic mode
–
F.01U.064.422 | V 1.0 | 2007.03
Basic mode - In this mode, Camera Installer detects all
cameras that are within range of the broadcast request (all
cameras within the network segment of the host PC) and
automatically assigns IP addresses to the cameras. It
selects those addresses that belong to the same sub-net-
work as the host PC itself and not yet assigned to other
network cameras. To detect and install the cameras auto-
matically, the user should simply press the Automatic but-
ton in the Basic mode. The installer will find, configure,
and verify the operability of the cameras, and will report
installation results as shown below. Once installation is
complete, the user should press the Save/Exit button to
save the setup information and exit the Installer.
Advanced mode - In this mode, the user can detect all cam-
eras present on the local area network and choose one or
more cameras for the installation. Furthermore, Advanced
mode allows you to issue the IP numbers of the cameras
User Manual
MegaPixel IP Cameras
Bosch Security Systems