Wiring Of The Transistor Outputs; Connecting Double-Coil Solenoids - Esu SwitchPilot User Manual

How to wire transistor outputs
Activation
button is possible
(Ground solder pad is
not available on all
models).
6.7. Wiring of transistor outputs
SwitchPilot

6.7.1. Connecting double-coil solenoids

You may use all commercially available double-coil solenoid drives
by all major manufacturers with SwitchPilot. Figure 4 shows how
to wire output 1:
a) The common wire of the solenoid is wired to screw
terminal C.
b) The wire leading to the first coil is connected to terminal Out
A.
c) The wire leading to the second coil is connected to terminal
Out B.
12
through
b)
Figure 5: Connection to transistor outputs 1 - 4
a)
c)
Should the aspect shown on your control panel not be as desired
(in other words: if straight and diverging route are exchanged)
simply swap the wires between terminals Out A and Out B.
SwitchPilot can also handle PECO® turnouts. However, their
current consumption is so high that you must adjust the overload
setting of the SwitchPilot. Please refer to chapter 9.3. for details.
As shown in Figure 5 the double-coil turnouts can be switched
with two optional push buttons without a digital command. The
needed ground solder pad is not available on all SwitchPilot
surfaces.
R