Siemens DMS8000 MP4.60 Manual page 11

Building Technologies
Fire Safety & Security Products
Note for MM8000 only
Note:
Supervisor System Settings > MM8000 / MT8001 System > Logical Configuration
> Point Page Extension
Uncheck the Automatic page calculation check box.
If a point is deposited in more than one map, then it will be associated with all of
them, in sequence (you can however modify the map order, see Associating
manual pages to points – MM8000 [➙ 33]).
Note: In order to check the associated map, you must close the MapMaker. This
will cause the points to be associated to the page or map, and this may take a
while.
A map is always displayed to operators as a page. That is, as a view of a specific
depth (a combination of layers with graphical zoom). In case of automatic
association to a point, the page is dynamically built up by MM8000, possibly
adjustment algorithm
applying an
include in the page all the points in the same tree-level (sibling points). For
example:
Map #1 is configured with one background ("BG") and three foreground layers

("FG1-Areas", "FG2-Sections", "FG3-Zones").
"FG3-Zones" contains 15 points of a CC11 unit, namely 15 zones (Z1, Z2, ... ,

Z15) of the same parent section S5.
"BG" and "FG3-Zone" are associated in a depth named "D3-Zones".

"D3-Zones" has been set to show Z1 on Map #1 with a zooming factor 500.

When MM8000 shows the page for Z1 in a treatment procedure step or in the Plant
Browser, it actually displays Map #1 as "D3-Zones" with zooming factor 650 (that
is, a bit enlarged or zoomed out) so as to include Z1 as well as Z2 to Z15 in the
view.
The page adjustment algorithm can be disabled for every page in the
corresponding Node tab. If disabled, no automatic zooming modification is applied
on the pages' depths.
Note: Zooming is not available for MT8001.
Configuring graphical maps - using the MapMaker
DMS8000 maps - general procedure
. Automatic association can be globally disabled in:
that may enlarge the depth's zooming factor to
2
11
A6V10062441_a_en
30.06.2013