Kedacom IPC4X1 Series User Manual page 19

High Speed Dome Camera
Go to Settings > Camera > Image > Night Cut, select night cut mode.
Day
Select Day from the dropdown list of Night Cut mode and disable IR lamp (only some models
support), and the image will become colored.
Night
Select Night from the dropdown list of Night Cut mode and enable IR lamp (only some models
support), and the image will become black and white.
Auto
Select Auto (gain triggered) or Auto (photosensor triggered) from the dropdown list of Night Cut
mode and configure Sensitivity / Photosensitivity, Latency and Night Cut Threshold. The system
will switch day/night mode automatically.
Scheduled Day / Night
In this mode, camera switches to day/night mode automatically in the preset period of time.
When selecting Scheduled Day/Night from the dropdown list, click Edit Time, and edit Day
Mode Start Time and Day Mode End Time in the popup interface.
4.1.2.6 Noise Reduction
When there are many noise points caused by environment and camera lens, Noise Reduction
function can be enabled to adjust images.
Go to Settings > Camera > Image > Image Enhancement, enable 2D/ 3D Noise Reduction
and drag the slide bar to adjust 2D/ 3D Noise Reduction level. When selecting "Disable", this
function will be disabled.
4.1.2.7 Defog
This function is suitable for outdoor foggy scene and after enabling it, the camera is able to see
through the fog.
Go to Settings > Camera > Image > Image Enhancement, select "Defog" from the dropdown
list of Image Enhancement and drag the slide bar of Defog Sensitivity.
4.1.2.8 EIS
EIS function is to prevent image flicker when the camera is zoomed in too much.
Go to Settings > Camera > Image > EIS, select "Enable" from the dropdown list of Mode and
drag the slide bar of EIS Level.
4.1.2.9 Rotate and BNC
Go to Settings > Camera > Image > Rotate and BNC, select Mirror Mode from the drop-down
list, options including Left and Right, Up and Down, Center and Disable. When the image is
reverse, set through this menu.
Cameras with BNC output ports will be able to output analog images directly after enabling BNC
output.
User Manual
15