Wiring The Modules - Mitsubishi Electric MELSEC iQ-R Series Quick Start Manual

Wiring the modules

Wire the power supply module.
Precautions
Before wiring modules, be sure to power OFF the system.
For wiring precautions, refer to the following manual.
MELSEC iQ-R Module Configuration Manual
1.
Wiring the power supply module.
The following shows an example of wiring the power wire and the ground wire to the power supply module.
Grounding should be provided to prevent electric shock and malfunction.
100/200 VAC
AC
2.
Wiring the output module.
The following shows an example of wiring the output module RY40NT5P.
L
L
+
-
The power supply line of the output device and that of the C Controller system should be wired separately as
shown below.
100 V AC
200 V AC
2 USING C CONTROLLER MODULE
8
2.2 Configuring the System
ERR
FG
LG
INPUT
100-240 VAC
Y0
Y1
Y2
Y3
Y4
Y5
Y6
Y7
Y8
Y9
YA
YB
YC
YD
YE
YF
+V
COM
Main
Power supply of
Relay
power
the C Controller
terminal
supply
system
block
Output power supply
Inside of a control panel
Insulation
transformer
C Controller
system
T1
Output device