Maintenance - Husqvarna PG 690 Operator's Manual

4. Attach the weight gas spring to the product (B).
a) Remove the locking spring of the ball joint.
b) Remove the ball joint from the gas spring.
c) Attach the ball joint to the product.
d) Attach the gas spring to the ball joint. Lock the
gas spring to the ball joint with the locking spring.
5. Lock the weight to the weight holder with the lock
ring.
Introduction
WARNING: Before you do maintenance, you
must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
To do before the maintenance
• Use personal protective equipment. Refer to
Personal protective equipment on page 10 .
• Use approved respiratory protection. The dust from
the product is dangerous to your health.
• Park the product on a level surface.
1163 - 003 - 22.01.2020
To adjust the weights
1. Push in the weight lock (A) and move the weight to a
selected position (B) with the weight handle. Refer to
Weights on page 31 .
2. Release the weight lock to lock the weight in the
selected position.

Maintenance

• Stop the motor and disconnect the power plug to
prevent accidental start during maintenance.
• Clean the area around the product from oil and dirt.
Remove unwanted objects.
• Set out clear signs to give a warning to bystanders
that maintenance work is in progress.
• Keep fire extinguishers, medical supplies and an
emergency phone near.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
WARNING: Be careful when you adjust the
weights. The moving parts can cause injury.
WARNING: Always make sure that the
weight lock locks correctly when the weights
are put in the selected position.
A
B
33