Table of Contents
Advertisement
a.
Check the fit of the various alignment tools on the display assembly. Make note of the best fitting
alignment tool to use when replacing the display panel.
b.
The display panel is secured to the display enclosure with tape that is installed under the left and
right sides of the panel. To remove the panel, use tweezers to grasp the end of the tape (1). While
turning the tweezers, wrap the tape around the tweezers (2) as you continue to pull the tape out
from behind the display panel (3). You must pull the tape multiple times before it is completely
removed.
c.
Rotate the display panel over and place it next to the display enclosure (4).
Display panels are available as the following spare part numbers:
M08527-001: 1000 nit panel
M08536-001: 250 nits, models with WWAN
M08539-001: 250 nits, models without WWAN, IR camera, Touch-on Panel (TOP)
M08540-001: 400 nits, models without WWAN, IR camera, ambient light sensor
d.
Lift the tape from the connector on the display panel (1), rotate the locking lever (2), and then
disconnect the cable from the panel (3).
Component replacement procedures
63
Hide quick links:
Advertisement
Table of Contents
