Table of Contents
Advertisement
6.
Lift the side of the system board upward (1), and then pull the system board away from the connectors
on the side of the computer to remove it (2).
Reverse this procedure to install the system board.
Display assembly
To remove and disassemble the display assembly, use these procedures and illustrations.
Full hinge-up displays are not available as spare parts. Spare parts for displays are available only at the
subcomponent level.
Before removing the display panel, follow these steps:
1.
Prepare the computer for disassembly
2.
Remove the bottom cover
3.
Disconnect the battery cable from the system board (see
4.
Remove the power connector cable
Remove the display assembly:
1.
Disconnect the display cable (1) and the antenna cables from the WWAN module (2), and then remove
the cables from the clip (3).
(Preparation for disassembly on page
(Bottom cover on page
33).
(Power connector cable on page
33).
Battery on page
43).
48).
Component replacement procedures
59
Hide quick links:
Advertisement
Table of Contents
