Husqvarna 129C Workshop Manual page 30

Repair Instructions
8
Still no spark?
Check other cables and connections for poor
contacts (dirt, corrosion, cable breakage and
damaged insulation). See figure 27.
Make sure that the cables are correctly drawn and
lie in the cable grooves.
Do not forget to check the cables in the throttle too.
See chapter "6.6 Dismantling the throttle".
TIP!
Use an Ohmmeter in order to easily check if
cable breakage has occurred, for example due to
pinching.
9
Still no spark?
Check the air gap between the flywheel magnet
and the ignition module. The gap should be 0.3
mm. Use the feeler gauge no. 502 51 34-02.
See figure 28.
10
Adjust the air gap as needed to the correct value.
• Loosen the bolts.
• Insert the feeler gauge between the ignition
modules and the magnets in the flywheel.
• Press the ignition module against the flywheel.
• Tighten the bolts and check the air gap again.
See figure 29.
If the spark plug still does not fire, the ignition
system should be replaced.
30
- English
Fig 27
Fig 28
Fig 29