Husqvarna 129C Workshop Manual page 29

4
If there is still no spark, remove the short-circuit
cable from the short-circuit switch.
Carefully remove the switch by inserting a small
screwdriver or knife into the short end of the
ignition switch. See figure 23.
If the plug now sparks, the fault is either in the
ignition switch or the short-circuit cable.
Change the switch as needed and check to see if
the cable insulation is damaged.
5
Still no spark?
Check the spark plug connection.
Remove the spark plug cover and make sure the
ignition cable is not damaged. See figure 24.
Remove a section of cable if required to make
proper contact with the connection coil.
6
When a section of the ignition lead has been cut
off, it helps to use the pliers no. 502 50 06-01 to
make a hole in the ignition cable to fit the ignition
coil. See figure 25.
NOTE!
It is important that the tip of the contact
coil hits the centre of the ignition cable to
prevent sparking.
7
Attach the ignition coil to the ignition cable and
ensure that the wire is folded along the cable.
Slide the ignition coil into the spark plug cover. See
figure 26.
TIP!
Lubricate the hole in the spark plug cover so that it
is easier to slide in the ignition coil.
Fig 23
Fig 24
Fig 25
Fig 26
Electrical system
29
English -