Husqvarna 241R Workshop Manual page 37

5
The angle gear has two purposes:
The fi rst is to gear down the engine's high speed to better suit the lower speed a saw blade or
trimmer requires to work effi ciently.
Secondly, the angle gear contributes towards the operator's working stance so that it is comfor-
table and at the same time effi cient. In other words, the power from the engine via the drive axle
should be angled so that the cutting tool works parallel with the ground.
36
Angle gear
Gear ratio
Model RJ: 1:1.29 (black grease plug).
Model R: 1:1.4.
Dismantling
Remove the angle gear from the shaft.
Remove the circlips holding the bearings
on the input respective output shafts.
Heat the entire angle gear to approx.
110°C and fi rst dismantle the input axle
and then the output axle.
Dismantling
Remove the cutting equipment and guard.
1. Remove the screws (A) and (B) and lift
off the plate (C).
2. Loosen the screws (D) and pull the
angle gear from the shaft.
3. Remove the circlip (D).
4. Remove the large circlip holding the
ball-bearing on the input shaft.
Heat the entire angle gear using a hot air
gun to approx. 110°C.
Knock the gear against a wooden block so
that the input axle and the bearing fall out.
Now lift out the output axle.
Wear protective gloves.