Husqvarna 241R Workshop Manual page 33

4
32
Centrifugal clutch
Dismantle the connection sleeve.
Dismantle the vibration element (F)
together with the clamping sleeve for pos-
sible replacement.
Dismantle the circlip and press out the
clutch drum.
Dismantle the circlip and heat the clutch
cover so the bearing can be dismantled.
Remove the screws (B), (C) and (D) and
lift off the connection sleeve (E) from the
clutch housing.
Press the vibration element (F) together
with the clamping sleeve out from the con-
nection sleeve with the help of a screwdri-
ver for possible replacement.
Dismantle the circlip using circlip pliers.
Press out the clutch drum using a suitable
punch and hammer.
Dismantle the circlip using circlip pliers.
Heat the clutch case to approx. 120°C
using a hot air gun.
Knock the edge of the cover against a
wooden block so the ball-bearing falls out
or use a hammer and punch.