Husqvarna 241R Workshop Manual page 21

3
20
Fuel system
Dismantle the main jet (A) and the plug
(B).
Assembling the carburettor
Blow the carburettor housing clean.
Fit a new plug.
Fit a new main jet.
Press out the main jet (A) with a suitable
punch.
Remove the plug (B).
Carefully drill a small hole (Ø 2 mm) in the
plug and pry it up with a pointed object.
Remove the valves and dampers. If these
components are worn, idling is disrupted.
Always replace the valves and dampers at
the same time.
Assembling the carburettor
• Blow all channels in the carburettor
compartment clean
• Mount a new plug.
Use a suitable punch to get a
completely tight seal.
• Press in a new main jet.