Husqvarna 241R Workshop Manual page 32

Centrifugal clutch
Dismantle the centrifugal clutch.
502 50 18-01
Twist apart the clutch and inspect the
different parts with regard to wear or
damage.
Clutch drum and drive
axle
Dismantling
Dismantle the shaft from the connection
sleeve.
Remove both screws (F) holding the cen-
trifugal clutch.
Lift off the clutch and both support wash-
ers.
Twist apart the clutch.
Inspect the different parts with regard to
wear or damage.
Pay special attention to the ends of the
springs, which in addition to wear, can
also show signs of cracking.
Assembly
Connect the clutch shoes together with
the spring.
NOTE!
Both clutch shoes should be
replaced even if only one of them is
showing signs of heavy wear. This
is to avoid engine vibration caused
by imbalance in the clutch.
Bolt the clutch on the fl ywheel. Do not
forget the washers (A).
Note the slots on the washer lie closest to
the fl ywheel. Align with the equivalent pins
on the fl ywheel.
Clutch drum and drive
axle
Dismantling
Loosen the three screws and pull off the
shaft from the connection sleeve.
4
31