Husqvarna 241R Workshop Manual page 10

Electrical system
Still no spark?
Check the ignition cable's connection to
the spark plug cover.
Use pliers no. 502 50 06-01 to make a
hole in the ignition lead.
502 50 06-01
Attach the ignition coil to the ignition
cable.
When there is still no ignition spark,
dismantle the short-circuit cable from the
stop switch.
Remove the connector by prying it up out
of the throttle with a knife.
If the plug now sparks, the fault is either in
the stop switch or the short-circuit cable.
NOTE!
The stop switch and the ignition
module are adapted to each other.
If the switch is damaged, it shall be
replaced with one of the same type.
Still no spark?
Check the spark plug connection.
Remove the spark plug cover and make
sure the ignition cable is not damaged.
Remove a segment of cable if required
to get suffi cient contact at the connection
coil.
When a part of the ignition lead has been
cut off it helps to use the pliers no.
502 50 06-01 to make a hole in the igni-
tion lead to fi t the contact coil.
NOTE!
It is important that the tip of the
contact coil hits the centre of the
ignition lead to prevent sparking.
Attach the ignition coil to the ignition cable
and ensure that the wire is folded along
the cable.
Slide the contact coil into the spark plug
cover.
TIP!
Lubricate the hole in the spark plug cover
so that it is easier to slide in the contact
coil.
2
9