Husqvarna 241R Workshop Manual page 13

2
12
Electrical system
Remove the fl ywheel.
502 51 49-01
Assemble the ignition module (part
number 501 31 98-01) and adjust the air
gap to 0.3 mm.
502 51 34-02
NOTE!
Do not forget the rubber bushings between the fuel tank and the crankcase/
clutch cover and the fuel tank and starter.
Dismantle the fl ywheel from the crankcase
using the puller
no. 502 51 49-01.
Gently knock the puller screw with a
hammer, if the fl ywheel sits tightly on the
crankshaft.
Assembly
Check that the cast key in the fl ywheel
and key way in the crankshaft are unda-
maged.
Fit the fl ywheel and centrifugal clutch. Do
not forget the washers (A).
Note the slots on the washer lie closest to
the fl ywheel. Align with the equivalent pins
on the fl ywheel.
NOTE!
The completely fl at side on the
clutch should rest against the
washer closest to the fl ywheel.
Assemble the ignition module (part
number 501 31 98-01).
Adjust the air gap. It should be 0.3 mm
between the permanent magnets in the
fl ywheel and the ignition module.
Tighten the screws and do not forget the
ring cable lug under the outer screw.
Assemble other parts in the reverse order
as set out for dismantling.
NOTE!
The stop switch and the ignition
module are adapted to each other.
An older version of an ignition
module may not be fi tted, as the stop
switch function is then altered.
If the ignition module needs to be
replaced, the new one shall have
part number 501 31 98-01.