Husqvarna 322HD60 Workshop Manual page 41

b) Clutch side.
7.14.3 To clean and examine the crankcase and
crankshaft
The crankshaft cannot be repaired. Replace it if it is
worn or damaged.
• Examine the large end of the connecting rod. If there
are marks, discoloration or damaged, replace the
crankshaft.
• Examine the small end of the connecting rod. If
there are marks or discoloration in the groove of the
bearing, replace the crankshaft.
1369 - 001 - 13.02.2020
• Examine the crankshaft bearing. There must be no
radial play in the connecting rod. Make sure that
there is axial play to sufficiently lubricate the
crankshaft bearing.
• Examine the crankcase halves for cracks and
damages.
7.14.4 To assemble the crankcase and crankshaft
1. Use a snap ring pliers to attach the snap ring on
each crankcase half.
a) Flywheel side.
Repair instructions - 41