Husqvarna 322HD60 Workshop Manual page 22

4. Put the end of the cable against the stop of the
assembly pliers, refer to
Then close the pliers to make the new hole.
5. Put the spring into the new hole.
6. Put the cable with the open spring into the other slot
in the pliers. Close the pliers to bend the spring.
CAUTION: Make sure that the spring is bent
90 degrees along the cable.
7. Lubricate the cap with soap and water or equivalent
to make it easier to push it into position.
22 - Repair instructions
Servicing tools on page 10 .
8. Push the cable into the spark plug cap.
9. Use the pliers or a screwdriver to align the spring
with the hole in the spark plug cap.
WARNING: Be very careful to prevent
damage to the spark plug cap. A damaged
spark plug cap can cause an electrical
shock.
7.8.6 To examine the ignition module
1. Remove the starter unit. Refer to
install the starter unit on page 14 .
2. Remove the muffler cover. Refer to
install the muffler on page 17 .
To remove and
To remove and
1369 - 001 - 13.02.2020