Husqvarna 322HD60 Workshop Manual page 11

Item Description
1 Removal tool for
the ball bearing
2 T-handle Torx,
T27
3 Carburetor ad-
justment tool
4 Carburetor ad-
justment tool
5 Removal tool for
the drive gear
6 Assembly pliers To repair the spark plug cable.
7 Piston stop
8 Test spark plug
9 Fuel filter hook
10 Removal tool for
the piston pin
11 Air gap gauge,
0.3 mm
12 Air gap gauge,
0.5 mm
13 Crankshaft as-
sembly sleeve
14 Flywheel remov-
al tool
15 Piston assembly
tool
16 Tachometer
17 Pressure tester
18 Grease, 400 g
19 Detergent
20 Air filter oil
1369 - 001 - 13.02.2020
Use
To remove ball bearings.
To loosen or remove Torx screws.
To adjust the idle speed screw on the carburetor.
To adjust the high speed needle and low speed needle on the carbu-
retor.
To remove the drive gear.
To stop the movement of the piston.
To do a spark test.
To pull the fuel filter out of the fuel tank.
To remove the piston pin.
To measure the distance between the flywheel and the ignition module. 502 51 34-02
To measure the electrode gap on the spark plug.
To assemble the crankshaft.
To remove the flywheel.
To assemble the piston.
To measure RPM.
To do a pressure test.
To lubricate the gear housing.
To clean the air filter.
To lubricate the air filter.
Article number
502 50 18-01
502 71 27-02
501 60 02-03
530 03 55-60
505 38 13-08
502 50 06-01
522 43 18-01
502 71 13-01
502 50 83-01
505 38 17-05
502 51 91-01
577 90 21-01
577 90 66-01
502 50 70-01
502 71 14-01
531 03 06-23
531 00 92-05
505 69 85-70
531 00 60-76
Servicing tools - 11