Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Husqvarna 322iHD60
Summary of Contents for Husqvarna 322iHD60
- Page 1 322iHD60 Operator's manual 2-19...
-
Page 2: Table Of Contents
Maintenance..............13 Introduction Product description Intended use Husqvarna 322iHD60 are battery hedge trimmers. Use the product to cut branches and twigs. Do not use the product for other tasks. Work is constantly in progress to increase your safety and efficiency during operation. Speak to your servicing dealer for more information. - Page 3 13. Mode button 14. Battery indicator button Protected against splashing water. 15. Battery 16. Battery release buttons 17. Charge indicator 18. Battery charger Do not lubricate. 19. Rear handle 20. Power trigger Symbols on the product Direct current. WARNING! This product is dangerous. Injury or death can occur to the operator or bystanders if the product is not Noise emission to the environment refer to...
- Page 4 if the instructions in the manual are not • If operating a power tool in a damp location is obeyed. unavoidable, use a residual current device (RCD) protected supply. Use of a RCD reduces the risk of electric shock. CAUTION: Used if there is a risk of Personal safety damage to the product, other materials or...
- Page 5 controlled with the switch is dangerous and must be • Follow all charging instructions and do not charge repaired. the battery pack or tool outside the temperature range specified in the instructions.Charging • Disconnect the plug from the power source and/or improperly or at temperatures outside the specified remove the battery pack, if detachable, from the range may damage the battery and increase the risk...
- Page 6 General safety instructions • Keep all parts of the body away from the blade. Do not remove cut material or hold material to be cut when blades are moving. Blades continue to move WARNING: Read the warning after the switch is turned off. A moment of inattention instructions that follow before you use the while operating the hedge trimmer may result in product.
- Page 7 Make a combination of noise level and long usage. sure that the cutting attachment stops completely. Husqvarna recommends that operators use hearing Remove the battery before you clean, inspect or protectors when using products for a longer coherent repair the product and/or the blades.
- Page 8 • Use gloves when necessary, for example when you for the address of your nearest service attach, examine or clean the cutting equipment. agent. • Use sturdy non-slip boots or shoes. To do a check of the user interface • Use clothing made of a strong fabric.
- Page 9 • Use the BLi battery that is rechargable as a power 1 second. supply for the related Husqvarna products only. To prevent injury, do not use the battery as a power To do a check of the hand guard supply for other devices.
-
Page 10: Introduction
• Do not use other battery chargers than the one WARNING: Read the warning supplied for your product. Only use Husqvarna QC instructions that follow before you do chargers when you charge Husqvarna replacement maintenance on the product. batteries BLi. -
Page 11: Operation
Battery information a) Make sure that the battery is installed correctly. If the battery can not move easily, the installation Refer to the operator's manual of the battery for of the battery is not correct. information about how to use the battery. b) Make sure that the battery locks into position. - Page 12 To select the cutting speed 2. Push and hold the power trigger lockout on the front handle. The product has a mode button. With the mode button the operator can limit the maximum speed. The mode button has 3 speed levels. A lower level increases the time of operation for the product.
-
Page 13: Maintenance
Maintenance Introduction Maintenance schedule The following is a list of the maintenance steps that you WARNING: Read and understand the must do on the product. safety chapter before you do maintenance work on the product. WARNING: Remove the battery before you do maintenance on the product. -
Page 14: Troubleshooting
To examine the blade 3. Use a file to remove burrs on the blade. 4. Make sure that the blades move freely. 1. Clean the blade from unwanted materials with an To lubricate the blade anti corrosion cleaning agent before and after you use the product. - Page 15 Problem Possible faults Possible solution Red error LED comes on. Speak to your servicing dealer. Transportation, storage and disposal Transportation and storage Speak to local authorities, domestic waste service or your dealer for more information. • The supplied Li-ion batteries obey the Dangerous Goods Legislation requirements.
- Page 16 ) at handles refer to EN 62841-4-2, m/s Front/rear han- 2.3/2.8 dles The Husqvarna Handheld Battery products marked with IPX4 fulfils these requirements on product approval level Noise emissions in the environment measured as sound power (L ) in conformity with EC directive 2000/14/EC.
- Page 17 Approved batteries Battery BLi200 Type Lithium-ion Battery capacity, Ah Nominal voltage, V Weight, kg Approved battery chargers Battery charger QC330 Input voltage, V 100-240 Frequency, Hz 50-60 Power, W 1865 - 002 - 14.06.2023...
- Page 18 Declaration of Conformity EU Declaration of conformity We, Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declare on our sole responsibility that the product: Description Battery-operated hedge trimmer Brand Husqvarna Type / Model 322iHD60 Identification Serial numbers dating from 2022 and onwards...
- Page 19 UK Declaration of conformity We, Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declare on our sole responsibility that the product: Description Battery-operated hedge trimmer Brand Husqvarna Type / Model 322iHD60 Identification Serial numbers dating from 2022 and onwards complies fully with the following UK regulations:...
- Page 20 Original instructions 1142959-26 2023-06-20...
Need help?
Do you have a question about the 322iHD60 and is the answer not in the manual?
Questions and answers