Husqvarna 322HD60 Workshop Manual page 16

7.3.5 To assemble the starter unit
1. Make sure that the recoil spring is installed in the
starter pulley. Install the recoil spring if it is
To install the recoil spring in the
necessary. Refer to
starter pulley on page 15 .
2. Attach the starter rope to the starter pulley. Install
the knot in the dedicated cut-out in the starter pulley.
3. Wind the starter rope 3 turns counterclockwise
around the starter pulley.
4. Lubricate the recoil spring in the starter pulley with
cold resistant grease.
5. Move the free end of the starter rope through the
starter rope guide (A) in the starter housing.
B
6. Carefully put the starter pulley into the starter
housing. Put the free end of the recoil spring into the
dedicated slot (B) on the hub of the starter housing.
7. Install the drive disc spring (C).
16 - Repair instructions
A
E
D
C
8. Lubricate the drive disc spring with cold resistant
grease.
9. Install the drive disc (D).
10. Install the screw (E).
11. Attach the starter rope handle to the starter rope.
12. Pull out the starter rope to its end position and hold
the starter pulley with your thumb.
13. Put the starter rope into the notch in the starter
pulley and turn the starter pulley 7 to 8 turns
clockwise.
14. Remove the starter rope from the notch in the starter
pulley.
15. Decrease the pressure of your thumb and let the
starter pulley rotate clockwise slowly.
16. Make sure that you can turn the starter pulley ½ turn
clockwise with the starter rope fully pulled out.
7-8 r
1369 - 001 - 13.02.2020