Dräger X-plore 6000 Instructions For Use Manual page 21

(2) Test with sealed exhalation valve
1. Remove the exhalation valve disc.
2. Insert the exhalation valve test plug.
3. Generate a negative pressure of 10 mbar.
4. If the pressure drop is less than 1 mbar/min, remove the
exhalation valve test plug and insert a new valve disc.
5. Repeat the leak test (1). If the full face mask leaks, continue
with (3).
(3) Leak test under water
1. Immerse the test head including the full face mask with exhalation
valve test plug in water.
2. Produce an overpressure of approx. 10 mbar.
3. Slowly turn the test head under the water surface. Emerging air
bubbles indicate leaks.
4. Take the test head with the full face mask out of the water, repair
the full face mask, replace leaking components.
5. Remove the exhalation valve test plug.
6. Install the exhalation valve disc.
7. Repeat the leak test (1).
After testing
1. Disconnect the adapter.
2. Remove the full face mask from the test head and dry it if
necessary.
3. Fit the exhalation valve cover so that it clicks into place.
Dräger X-plore 6000
5 Transport
Transport full face mask in a carrying box or mask bag.
6 Storage
Loosen the harness as far as possible.

Wipe the visor with an antistatic cloth.

Make sure that the full face mask is dry.

Pack the full face mask in its bag or carrying box.

Store the full face mask in a dry, dust-free place where it cannot

become deformed.
Protect from direct sunlight and thermal radiation.

Storage temperature: –15 °C to +25 °C

Observe ISO 2230 and national regulations concerning the

storage, maintenance and cleaning of rubber products.
Dräger rubber products are treated with an agent to protect against
premature ageing which in some cases is visible as a grey-white
coating. This coating can be washed off with a brush and soapy water.
7 Disposal
Dispose of the full face mask and used filters according to the
applicable regulations.
(approved by Dekra Exam)
Transport
21