Step 3 Adjusting The Brightness Of The Screen; Advanced Setting - NovaStar MCTRL660 User Manual

network interface.
ii. In the case of special-shaped cabinets, different cabinet size and special-shaped screen, the
NovaLCT-Mars software is required to be connected to configure the screen.
iii. During connection setting, you can rotate the knob to see the effects of different connections on
the screen in real time. If you are satisfied with the connection, you must press the knob to save the
setting. You can press the return key to exit from the current operation.
iv. During connection setting, you must ensure that the connection of each network interface is
downward in the same direction.
v. During connection setting, you must ensure that network interface 1 is the start position of the
whole connection.

7.3 Step 3 Adjusting the Brightness of the Screen

Return to the main menu interface. Press the knob to select the corresponding value. You can rotate the
knob to adjust the brightness at this time.

7.4 Advanced Setting

Enter the submenu of advanced setting, rotate the knob, and then the user can see the following eight
setting options contained in advanced setting. The user can set the parameters by taking the following
www.novastar.tech
Controller MCTRL660 User's Manual
according to the actual situation when setting the
screen. The number of receiving cards for network
interface 3 must be smaller than or equal to cabinet
out1 QTY.
15