Slave Address For The Ics (8 Bits) List; Error Code List - Omron STC-HD203 Series Product Specifications And User's Manual

Slave address for the ICs (8 bits) list

IC
DSP
EEPROM
EEPROM
EEPROM
EEPROM
EEPROM
EEPROM
EEPROM
EEPROM
EEPROM
uCOM
EEPROM
Note: There is maximum number of writing to EEPROM of 1,000,000 times.

Error code list

If an error occurs, the camera sends an error code with the following format:
The Command number of the Error Message is FF (HEX). The Data length is 0002.
Error
Check sum does NOT match the data being transmitted
The command being transmitted does NOT exist or is invalid
Unprocessed data remains in the receiving buffer
Time out
Over run error
Framing error
Data length error (too long)
I2C communication error
Note.1: The camera disregards the data, which is not start with SOF.
Note.2: The time out error is occurred when does not receive the next data 3 seconds after receive the data.
STC-HD203DV / STC-HD203DV-CS / STC-HD203SDI / STC-HD203SDI-CS
Product Specifications and Users Guide
Slave Address
80 DSP data
60 The Virtual EEPROM zone for the currently selected DSP preset
mode of Preset0 to Preset7
90 The EEPROM zone for the Preset0 DSP data
91 The EEPROM zone for the Preset1 DSP data
92 The EEPROM zone for the Preset2 DSP data
93 The EEPROM zone for the Preset3 DSP data
94 The EEPROM zone for the Preset4 DSP data
95 The EEPROM zone for the Preset5 DSP data
96 The EEPROM zone for the Preset6 DSP data
97 The EEPROM zone for the Preset7 DSP data
20 The uCOM data
40 The EEPROM zone for uCOM Data
詳細
Receive data
02, FF, 00, 02, 03, 00, 04, 03
02, FF, 00, 02, 04, 00, 05, 03
02, FF, 00, 02, 05, 00, 06, 03
02, FF, 00, 02, 06, 00, 07, 03
02, FF, 00, 02, 08, 00, 09, 03
02, FF, 00, 02, 09, 00, 0A, 03
02, FF, 00, 02, 0B, 00, 0C, 03
02, FF, 00, 02, 10, 00, 11, 03
No. 13S054-10
37/78